Instruction manual
12
Manually record a video or photo.
A. In the talk state, press the up button to start recording a video or
take a photo.
B. Press up button again to stop recording.
C. When power is supplied to the outdoor unit, first press the monitor
button and then press the up button to take a picture or start
recording.
D. Press the up button again to stop.
4.12 TIME SETTING
A. Use the arrow keys to select the time setting icon
B. Press menu/ok to confirm.
C. Press left/right buttons to select the setting you want to change.
D. Press up/down buttons to adjust.
E. Press menu/ok to confirm.
4.13 UNLOCK TIME SETTING
This setting defines the duration of which the door lock stays
unlocked after pressing the “open door lock button”
A. Use the arrow keys to select the unlock time icon ,
B. Press menu/ok to confirm.
C. Use the left/right button to select between 100mS, 1S, 5S or 10S.
D. Confirm and exit by pressing the menu/ok button.
5 Cleaning and maintenance
• Clean the outside of the appliance with a soft and slightly
moistened cloth.
• Do not use any carboxylic cleaning agents or petrol, alcohol or
similar. These attack the surfaces of the devices. Besides, the
vapors are hazardous to your health and explosive. Do not use
any sharp edged tools, screw drivers, metal brushes or similar for
cleaning.
6 Frequently asked questions
Problem Solution
• The indoor unit does not
switch on.
• Make sure that the monitor is
connected to the power
source.
• Make sure the adapter plug is
properly pushed in to the
power outlet.
• The ring tone volume is too
low.
• Perhaps you extended the
cable. Extending the cable
can reduce the volume due to
being too long or too thin.
• I connected the indoor unit to
a lock but it does not work.
• Check if the lock is connected
properly and that a suitable
lock with an external power
source is used.
To Next Page
Loading...
