15
C.Scope Locators can be powered by either eight standard alkaline
or by eight standard Nickel-Metal Hydride rechargeable (NiMH) AA (LR6) size batteries.
Locator Battery Check
Switch the Locator on by pulling up on the On/Off trigger positioned on the underside of the handle.
The Locator should emit a clear audible battery check tone for one second and the display should come on.
Check the battery level indicator in the bottom
left hand corner of the display. If there is only
one segment or no segments of the indicator
filled in then the batteries will need to be
renewed or recharged before locating work
can begin.
Changing Locator Batteries
Push the two clips back to release the battery compartment door. Remove ALL EIGHT used batteries and replace with
new ones. Be careful to insert the new batteries the correct way round in the holder. Replace the holder in the battery
compartment making sure that the two terminals on the holder make contact with the two terminals within the battery
compartment. Close the battery compartment door securely.
Using the Locator: Batteries Alkaline and Rechargeable
WARNING Do not change batteries in confined spaces where gas may be present.
WARNING Do not mix old and new or different types of batteries.
NOTE A spare battery pack can be carried inside the battery compartment.
NOTE Only use alkaline or Nickel-Metal Hydride (NiMH) rechargeable AA (LR6) size batteries.
NOTE Dispose of the used batteries safely in accordance with local regulations.
NOTE The Locator will carry out an automatic Self Test when it is
switched on for the first time each day (see pages 16-17 for full details)
Battery Levels OK
replace / recharge
batteries
To Next Page
Loading...
Need help?
General