Need help?Do you have a question about the C-TEC XFP and is the answer not in the manual?
General| Model | XFP |
|---|---|
| Category | Control Panel |
| Type | Fire Alarm Control Panel |
| Display | LCD |
| Power Supply | 230V |
| Compliance | EN54-2 |
| Compatibility | C-TEC |
| Operating Temperature | 40°C |
| Relative Humidity | 95% non-condensing |
Provides a general overview of fire alarm systems and their purpose.
Details the XFP panel's intelligent addressable capabilities and features.
Explains the different access levels (1, 2, 3) and their capabilities.
Lists key responsibilities for the person in charge of the fire alarm system.
Details weekly and monthly testing procedures required by BS5839-1.
Explains the need for professional, periodic inspection, testing, and maintenance.
Illustrates the layout of controls and indicators for a 16-zone panel.
Illustrates the layout of controls and indicators for a 32-zone panel.
Explains the meaning of various LED indicators on the panel.
Explains the function of various buttons on the control panel.
Describes the function of the keyswitch for accessing different levels.
Details panel messages and their interpretations for user understanding.
Explains the messages displayed when the system is in a normal state.
Describes panel indicators and display during a fire event.
Explains how multi-zone fire conditions are displayed.
Explains fire condition display when output delays are active.
Details panel indications for 1st-stage fire conditions.
Explains how to interpret zone dependency alarms.
Explains how to interpret investigation delay alarms.
Describes panel indications for pre-alarm conditions.
Describes panel indicators and display for fault conditions.
Lists actions for the responsible person during a fault.
Details how to enter access level 2 using a code or keyswitch.
Warns against unauthorized access to engineer level.
Explains how to view active fire conditions on the panel.
Explains how to view active fault conditions on the panel.
Explains how to view active disablements on the panel.
Explains how to view zones currently in test mode.
Describes how to perform a lamp test on the panel's indicators.
Explains how to view the panel's fire alarm event count.
Details how to enter access level 2 via pushbuttons and code.
Details how to enter access level 2 via the keyswitch.
Explains how to silence active alarm sounders.
Explains how to resound silenced alarm sounders.
Describes how to reset the panel after an alarm.
Details the lamp test procedure for panel indicators in Access Level 2.
Explains how to view and reset the panel's alarm count in Access Level 2.
Covers printing, displaying, and resetting the panel's event log.
Explains how to disable or enable specific zones.
Explains how to disable or enable sounder groups.
Explains how to disable or enable output sets.
Explains how to disable or enable panel relays.
Explains how to individually disable/enable devices.
Explains how to disable the fault relay.
Explains how to disable/enable output delays.
To Next Page
