6
2 Technical Data
Technical data 4S/450 4S/600
Separation type Component side:
Soldering side:
circular blade
linear blade
Operation motorized and optimized
Separation speedt 300/500 mm/sec. switchable
Material FR4, Aluminium
Height of components Component side/Soldering side up to 34 mm
Cutting length , continuous F up to 450 mm up to 600 mm
Length D 702 mm 852 mm
Depth storage table 200 mm
Programming
Home Request drive to starting position, Acknowledge
Speed H (High): 500 mm/Sek.
L (Low): 300 mm/Sek.
Program 9
Step (cutting steps) 1 – 5
Distance (between blades) 0,9 mm bis 0,05 mm
Key switch button Release of programming
Mileage (Kilometer counter) up to 99,99 km
DEL Reset of the kilometer counter
Power switch ON/OFF
Foot switch START Separation
Safety switch Emergency stop
Spannung 100–240 V~ 50/60 Hz
Emission sound pressure level LpA < 70 dB (A)
Temperature / humidity not
condensing
Operation +10–35°C / 10–85%
Stock +20–50°C / 20–80%
Transport -25–50°C / 20–80%
Weight 38 kg 46 kg
Height/Depth 434x425 mm
Width 702 mm 852 mm
Approvals CE, FCC class A
Dimension Maximum Height of components on the cut nut
27 21,5
3434
400...40
10˚
10˚
Enlargement of the PCB outside after separation. typical 0,2 mm
30˚
FR 4
0,8-3,2
min. 0,25
max. 0,8
30˚
Alu
0,8-1,5
min. 0,25
max. 0,3
The cut nut could be broken by a cutout.
In case of overlaying components, the linear blad
must be hollowed.
If required request.
Table 2 Technical data
To Next Page
Loading...
