CAC / BDP RG57F3(B) - User Manual

Service Manual
RG57F3(B)/BGEFU1
Wireless Remote Controller
TABLE OF CONTENTS
PAGE
INTRODUCTION 1...................................
HANDLING THE REMOTE CONTROLLER 2.............
STANDARD FUNCTION BUTTONS 3...................
ACCESSING THE SERVICE FUNCTIONS 4...............
REMOTE CONTROLLER SERVICE FUNCTIONS 4........
Auto−Start Function (F1) 4.............................
Heating Temperature Compensation (F2) 4................
Anti−Cold Air Function (F3) 5..........................
Indoor Fan Motor Speed Control after Set Temperature is
Reached (F4) 5......................................
Louver Angle Memory Function (F5). 6...................
Heating Only or Cooling and Heating Setting (F6). 6.........
Cooling Temperature Compensation (F7). 6................
Refrigerant Leakage Detection (F8). 6....................
Cleaning Filter Reminder (F9). 6........................
Filter Replacement Reminder (E1). 7.....................
Lowest Temperature Setting (E2). 7......................
Highest Temperature Setting (E3). 7......................
Special Anti−Cold Air Function Setting (E4). 7.............
Priority Setting of Heating or Cooling (only on Multi−Zone
Systems) (E5). 7.....................................
Network Address Setting (E6). 7........................
Capacity Code Selection (E7). 7.........................
Twins Setting (E8). 7.................................
Static Pressure Setting (E9). 7...........................
DEFAULT VALUES OF INDOOR UNITS 8................
POINT CHECK FUNCTION 9...........................
INTRODUCTION
This service manual provides the necessary information to use the
service functions on the RG57 wireless remote controller. Use the
Table of Contents to locate a desired topic.
Fig. 1 – Remote Controller

Summary

Introduction

Handling the Remote Controller

Remote Controller Location

Specifies the optimal distance and conditions for remote controller signal reception.

Replacing Batteries

Provides step-by-step instructions for replacing the remote controller's batteries.

Standard Function Buttons

Basic Controls

Covers ON/OFF and MODE buttons for primary unit operation.

Environment Control

Buttons for adjusting temperature, fan speed, airflow, and comfort modes.

Timers and Indicators

Functions for setting timers and managing unit indicators like LED and Swing.

Accessing Service Functions

Auto-Start Function (F1)

Configures the unit to resume previous operation automatically after a power failure.

Heating Temperature Compensation (F2)

Allows adjustment of thermal stratification and room sensing for heating.

Anti-Cold Air Function (F3)

Indoor Fan Motor Speed Control after Set Temperature is Reached (F4)

Louver Angle Memory Function (F5)

Heating Only or Cooling and Heating Setting (F6)

Cooling Temperature Compensation (F7)

Refrigerant Leakage Detection (F8)

Cleaning Filter Reminder (F9)

Filter Replacement Reminder (E1)

Lowest Temperature Setting (E2)

Highest Temperature Setting (E3)

Special Function Setting (E4)

Priority Setting of Heating or Cooling (only on Multi-Zone Systems) (E5)

Network Address Setting (E6)

Capacity Code Selection (E7)

Twins Setting (E8)

Static Pressure Setting (E9)

Default Values of Indoor Units

Point Check Function

CAC / BDP RG57F3(B) Specifications