Power Seats
If the vehicle has power seats, the controls used to
operate them are located on the outboard side of
the seats.
• Move the seat forward or rearward by sliding the
horizontal control forward or rearward.
• Raise or lower the front part of the seat cushion by
moving the front of the horizontal control up or down.
• Raise or lower the rear part of the seat cushion by
moving the rear of the horizontal control up or down.
• Raise or lower the entire seat by moving the entire
horizontal control up or down.
The vertical control is used for reclining your seatback.
See “Power Reclining Seatbacks” under Reclining
Seatbacks on page 1-5 for more information.
Power Lumbar
Your vehicle may have this
feature. The driver’s and
passenger’s seatback
lumbar support can
be adjusted by moving
the control located on
the outboard side of the
seat cushions.
To increase or decrease support, hold the control
forward or rearward. Keep in mind that as your
seating position changes, as it may during long trips,
so should the position of your lumbar support.
Adjust the seat as needed.
1-3
To Next Page
Loading...
Need help?
General
