50 Infotainment System
Maps
This section includes basic
information needed to know about
the map database.
Map Coverage
The navigation maps are stored on
the hard drive.
For more information on map
coverage, see “Navigation Settings”
earlier in this section.
Installing the DVD Map Disc
The factory installs the map
database information on the HDD.
An updated map disc can be used
to update the map database
information, see Ordering Map
DVDs on page 81 later in this
section.
Before updating the map database
on the HDD, read the following
steps:
1. Turn ignition on.
2. Press VOL/
O to turn the
system on.
3. Insert the map update disc into
the slot, label side up.
4. Press the Update screen button
when the Update Confirmation
screen displays.
5. Enter the Authentication Code
screen button, then press the
Enter screen button.
6. If the correct code is entered,
the system starts updating and
the status bar displays.
7. Press
X after the map
database update is completed.
If the application update file is
included in the disc, the application
update is also done.
Handling the DVD Map Disc
.
Handle the disc very carefully to
avoid contamination or flaws.
Signals might not read out
properly.
.
Use a soft cloth if the disc gets
soiled and gently wipe it out from
the center of the disc to the
outside. Do not use cleaners or
solvents.
.
Do not use the disc to rest on
while writing or drawing using
any writing utensil or attach a
seal to any of the sides or
the disc.
.
Do not keep the disc in direct
sunlight, high temperatures,
or humidity.
.
Place the disc back into the
original case after use.
To Next Page
Loading...
Need help?
General
