49-2000573 Rev. 5 31
Oven Probe
The temperature probe may be cleaned with soap and
water or a soap-filled scouring pad. Cool the temperature
probe before cleaning. Scour stubborn spots with a soap-
filled scouring pad, rinse and dry.
To order additional temperature probes, see the
Accessories and Consumer Support sections at the end
of this manual.
■ Do not immerse the temperature probe in water.
■ Do not store the temperature probe in the oven.
■ Do not leave the temperature probe inside the oven
during a self or steam clean cycle.
CARE AND CLEANING: OvenProbe/Drawer
Removable Warming Drawer
NOTE: For models with an electric warming drawer,
before performing any adjustments, cleaning or
service, disconnect the range electrical power supply
at the household distribution panel by removing the
fuse or switching off the circuit breaker. Make sure
the warming drawer heating element is cool.
Most cleaning can be done with the drawer in place.
However, the drawer may be removed if further cleaning
is needed. Use soap and warm water to thoroughly clean.
To remove the drawer:
1. Pull drawer straight out until it stops.
2. Press the left rail release up and press the right rail
release down, while pulling the drawer forward and
free.
To replace the drawer:
1. Place the left drawer rail around the inner left rail
guide and slide it in slightly to hook it.
2. Place the right drawer rail around the inner right rail
guide and slide it in slightly to hook it.
3. Slide the drawer all the way in.
Drawer
To Next Page
Loading...
