Cal-Royal CRCODE-202 - Inside Lock Installation; Install Strike Plate; Check and Adjust

Inside Lock Installation
Install Strike Plate
Check & Adjust
1. Place Inside Lock onto the door.
3. Fasten with 4 screws.
2. Push lever onto the hub until it clicks.
1. Align strike plate with rabbet.
2. Fasten strike plate with 2 screws.
1. Enter factory set code and make sure that the latchbolt
retracts and the lever handle turns smoothly.
2. Check the operation of the inside lever handle.
3. Insert the key to check if the latchbolt retracts.
4. Close the door and make sure it closes without getting
stuck. (Remove the key before closing the door)
5. Enter the code or use the key to open the door.
6. If there is no binding of the latch or handles, the lock is
FRUUHFWO\¿WWHG2WKHUZLVHORRVHQWKH¿[LQJEROWVDQG
reposition the strike plate slightly until the correct
position is found. Re-tighten the bolts.
9
6605 Flotilla St., Commerce, CA 90040
Tel (323) 888-6601 Fax (323) 888-6699
www.cal-royal.com