How to fix cloudy water in my Cal Spas LES?
To address cloudy water in your Cal Spas Hot Tub, you can try the following: * Clean the filter. * Shock the spa with sanitizer. * Add sanitizer. * Adjust the pH and/or alkalinity to the recommended range. * Run the jet pump and clean the filter. * Drain and refill the spa.
How to eliminate water odor in Cal Spas Hot Tub?
To get rid of water odor in your Cal Spas Hot Tub, try shocking the spa with sanitizer, adding sanitizer, and adjusting the pH to the recommended range.
Why is there algae growth in my Cal Spas LES Hot Tub?
Algae growth in your Cal Spas Hot Tub can be caused by high pH or a low sanitizer level. Shock the spa with sanitizer if the problem is visible or persistent, or drain, clean, and refill the spa.
How to remove scale from Cal Spas LES Hot Tub?
Scale buildup in your Cal Spas Hot Tub can be caused by high calcium content in the water or total alkalinity and pH being too high. Adjust the total alkalinity and pH. If scale requires removal, drain the spa, scrub off the scale, refill the spa, and balance the water.
How to clean organic buildup in Cal Spas LES?
If you notice organic buildup or a scum ring around your Cal Spas Hot Tub, it's likely due to a buildup of oils and dirt. Wipe off the scum with a clean rag. If the buildup is severe, drain the spa, use a spa surface and tile cleaner to remove the scum, and then refill the spa.
How to remove stains from Cal Spas LES?
Stains in your Cal Spas Hot Tub can occur if the total alkalinity and/or pH is too low, or if there's high iron or copper in the source water. Adjust the total alkalinity and/or pH. If the issue is high iron or copper, use a stain and scale inhibitor.
Why does my Cal Spas Hot Tub cause eye irritation?
Eye irritation from your Cal Spas Hot Tub can occur due to low pH or low sanitizer level. Adjusting the pH and shocking the spa with sanitizer, as well as maintaining the sanitizer level, should help resolve this issue.
What to do if Cal Spas LES causes skin irritation?
Skin irritation or rash from your Cal Spas Hot Tub can be due to unsanitary water or a free chlorine level above 5ppm. Shock the spa with sanitizer and maintain the sanitizer level. Also, allow the free chlorine level to drop below 5 ppm before using the spa.
Guide to finding your spa's serial number for registration and warranty activation.
Covers drowning risks, electrical shock, hyperthermia, and general injury reduction.
Details on GFCI testing, infectious diseases, entry/exit care, and prolonged immersion.
Guidance on site selection, foundation, service access, and electrical installation.
Steps for filling the spa, powering up, priming the pump, and installing the filter.
Explains the control panel interface, button functions, and menu navigation.
Configuration of temperature, filter cycles, heat modes, and other settings.
Identifies common error messages and provides troubleshooting steps.
Covers Wi-Fi app control, network setup, and special climate operations.
How to control jets, LED lighting, diverter valves, and waterfalls.
Covers chemical balance, testing, sanitation, filtration, and maintenance schedules.
Definitions of key terms like pH, TA, CH, Scale, Shock, etc.
Procedures for adding chemicals and balancing TA, CH, and pH levels.
Guidance on sanitizers, shock treatments, and regular maintenance for clear water.
Common problems like cloudy water, odor, irritation, and their solutions.
Instructions for removing pillows and servicing spa jets.
Procedures for draining, winterizing, cleaning/replacing filters, and vacation care.
Guide to installing the cover, locking system, and cleaning the spa shell.
How to connect and use the spa's Bluetooth sound system.
Listing of various spa parts including jets, valves, drains, filters, and lights.
Solutions for common spa problems like pump issues, no heat, and control panel errors.
Solutions for pump problems, overheating, and water pressure issues.
Explanation of thermal creep and methods to manage it.
Details on shell, equipment, plumbing, cabinet, and other component warranties.
Conditions that void the warranty, exclusions, and service procedures.
To Next Page
General