[M] Meters — This is an entry and
conversion key that works in the
same way as the [Yds] key described
above.
[CM] Centimeters — This is an entry
and conversion key used to enter
decimal centimeters or to convert
decimal centimeters from some
other dimensional format when
used in conjunction with the [Conv]
key.
[MM] Millimeters — This is an entry
and conversion key that works in
the same way as the [CM] key de-
scribed above.
[Cu] Cubic — This definition key is used
in conjunction with a dimension key
(feet, yards, meters, etc.) to enter a
volume measurement. Example: 5
[Cu] [Yds]. Three linear dimensions
multiplied together also equal a
cubic dimension.
[Sq] Square — Similar to the [Cu] key,
this definition key is used in con-
junction with a dimension key (feet,
inches, yards, meters, etc.) to enter
an area measurement. Example: 10
[Sq] [Feet]. Also, two linear dimen-
sions multiplied together equal a
square dimension.
8 — Construction Master III
®
To Next Page
Loading...
