4 — PREXISO X2 QUICK START GUIDE
HOW TO USE
Measuring conditions
The quality of the measurement depends on the surfaces to which you are
measuring. Strongly reflecting targets deflect the laser beam and cause mea-
suring errors. Non-reflecting, dark surfaces increase the measuring time.
Always begin by making a control measurement.
Measurement errors
Measuring errors are possible in case of:
• Colorless fluids (e.g., water)
• Clean, translucent glass
• Styrofoam or similar semi-translucent surfaces
• Strongly reflecting targets that deflect the laser beam
• Measurements aimed at moving objects
For consistently accurate measurements
• Perform control measurements periodically.
• Perform control measurements before and after important measurements.
Switching on/off
(Key 1)
/
(Key 3)
• Switch on the device by pressing Clear/Off
(Key 1). The device shows the
Battery and Measuring Plane symbols until another key is pressed.
• Switch off the device by pressing Clear/Off
(Key 3) for 2 seconds. If no
key is pressed for 3 minutes, the device switches off automatically.
Clear key
(Key 3)
• Undo the most recent action by pressing Clear/Off (key 3)
briefly.
Adjusting the measuring plane
Rear measuring plane is the
standard setting.
• For measurement from front edge,
press Measuring Plane/Units
(key 4) briefly.
• For measurement from rear edge,
press Measuring Plane/Units
(key 4) briefly again.
To Next Page
Loading...
Need help?
General
