3
INSTALLER
3 - Main features
The SATK’S remote control device is
electrically connected to th
e heat interface
unit by means of two non polarized
conductors. They give it the necessary
supply to operate and constitute also the
communication between the two devices.
After installing it is immediately ready to run
with its memorized standard program. This
program can be changed according to the
needs of the user.
The programming of the SATK’S
remote control device is extremely
easy -
a large LCD-display makes
it possible to check and change the
set values at any time.
To Next Page
Loading...
Need help?
General
