To Next PageTo Next Page
Need help?Do you have a question about the Calorex PPT16 and is the answer not in the manual?
General| Model | PPT16 |
|---|---|
| Category | Heat Pump |
| Heating Capacity | 16 kW |
| Refrigerant | R410A |
| COP (Coefficient of Performance) | 4.2 |
| Power Supply | 400V/3Ph/50Hz |
Explains the thermodynamic principle and operation of the Calorex heat pump using a vapour compression cycle.
Details the accessories supplied with the heat pump for installation, including rubber feet and pipe connectors.
Provides guidance on selecting an appropriate location for the heat pump, considering base, clearance, and noise.
Details the air flow requirements and best positioning for optimal performance, avoiding recirculation.
Illustrates the recommended plumbing layout for the heat pump installation, including connections and bypass.
Details how to set and check the water flow rate for the heat pump using the flow switch.
Covers electrical standards, protected supply requirements, earthing, and RCD recommendations.
Identifies the location of electrical input and external interlock terminals on the unit for connection.
Explains how to synchronise the heat pump with the pool pump's timer to override 'pump off' periods.
Wiring diagram for PPT8/12 ALX/ALY single phase 230V~1N 50Hz models.
Circuit diagram for PPT16/22 ALX single phase models.
Circuit diagram for PPT12/16/22 BLX/BLY three phase 400V~3N 50Hz models.
Circuit diagram for PPT16 ALY single phase models.
Circuit diagram for PPT22 ALY single phase models.
A checklist for users to identify potential heat pump malfunctions based on thermostat indicators and error messages.
Step-by-step guide for restarting the heat pump after winter storage, including cleaning and system checks.
