2017 Portable Spa
LTR20171001, Rev. C
Preparing for Your New Portable Spa
www.calspas.com
13
4. Turn on power to the spa.
When the spa is lled to the correct level, turn on the
power at the GFCI breaker. (Ensure that the 120V spas are
connected to the proper electrical outlet.)
3. Fill the spa.
Fill the spa until water level is about six inches from the top.
If the water level is too low or too high, your spa will not operate properly.
Never ll your spa with soft water.
Soft water makes it impossible to maintain the proper water chemistry and may cause the water to
foam, which will ultimately harm the nish of the spa and void your warranty.
Place a garden hose in the lter canister and ll your
spa.
Always ll the spa through the lter canister.
Failure to do so may cause air to be trapped in the
ltration system and prevent the pumps from operating
properly.
To Next Page
Loading...