Calspas patio plus - Bromine Generator Operation; Bromine Generator Start-up and Use; Intelligent Controller Codes

2017 Portable Spa
LTR20171001, Rev. C
Operating Your Spa
www.calspas.com
36
Adjustable Therapy System
Pump On / Off Button
Press this button once to turn on the ATS pump. The
POWER ON light on the control panel will appear.
Press this button a second time to turn off the ATS
pump. The ATS pump must be on before you can use
any other features of this system.
Pulse Mode Button
Press this button once to turn on the Pulse Mode.
The rst time it is pressed, the orange LED in position
number 1 will light, indicating the number one pulse
mode. Each press of either the Up or Down button
will move the orange LED up or down to the next
pulse mode. There are seven pulse modes in all. See
the image at right.
Allow one second between each button press. Pressing
the button quickly may cause improper operation. To
turn the Pulse Mode off and return to normal pump
operation, press the Pulse Mode button a second
time.
Up / Down Buttons
As described above, these buttons allow you to cycle
through seven massage modes. Each mode offers a
different pulsating massage. Some modes are faster
than others, so just cycle through them to nd the
massage you like best.
Time Reset
Pulse Mode will normally run for 15 minutes then
automatically shut off. For another 15-minute session,
press the Pump On / Off button and the Pulse
Mode button. A light will blink and the pump will run
on high-speed mode as part of a 15-minute cool down
period. After that, the pump will stop automatically
and the LED light on the panel will continue to blink
1
Low rolling bursts
2
Medium connuous burst
3
Accelerated connuous bursts
4
Swi rolling bursts
5
3 gentle bursts followed by 1 vigorous burst
6
Quick powerful, connuous bursts
7
Gentle & powerful alternang bursts
for one minute then
shut off automatically.
After the second
15-minute session, the
system will run through
a cool down cycle for
up to two hours. In this
cool down mode, the you
will only be able to operate
the pump (by again pressing the
Pump On / Off button). However, the massage mode
will remain off until the cool down mode is completed.
Resetting Pulse Mode
Pulse Mode will shut off for two hours unless reset.
During this time the pump will run at a maximum
speed. To reset Pulse Mode, press the Pump
On / Off to turn off the ATS pump, the press
the Pulse Mode button once. The power light
will ash to indicate Pulse Mode has been reset.
Jets
Aux
Warm Cool Light
Pulse Modes
Microsilk Therapy System
The optional Microsilk feature is available with Connect and Escape spas only.
The Microsilk system generates microbubbles that are 50 to 100 times smaller than ordinary air
bubbles. The microbubbles are oxygen-rich and help hydrate your skin.
Press the Aux button to start the Microsilk pump. When the spa water becomes saturated with the
microbubbles, it will turn white to create an ideal Microsilk environment.
The Microsilk pump will run for 15 minutes or until you press Aux to turn it off. When the pump cycle nishes,
you can press Aux to start the Microsilk pump again.