19/28
6.2. Operating instructions
Perform the daily maintenance check before each use as described in chapter ‘7.3. Maintenance
instructions’.
Make sure you follow the steps below before you put the pallet forks frame into operation:
1. Mount the FEM attachment/FEM forks onto your pallet forks frame (see chapter ‘5. Assembly and
installation of the product’).
2. Before lifting the FEM attachment/FEM forks, make sure it is/they are secured safely.
3. Slightly lift the FEM attachment/FEM forks to make sure the attachment is secured. If not, lower
and reposition to provide full stability.
4. Do not lift higher than recommended.
5. During transport, keep the pallet forks frame centred and horizontal, gradually accelerate/brake,
slow down before turning and drive carefully on rough terrain.
To Next Page
