p. 23 - Manual FA00995-EN - 01/2018 - © CAME S.p.A. -
Translation of the original instructions
Partial opening
Select the DIP-switches as shown and press the PROG button for one second. The PRG LED
blinks. Within 20 seconds, enter a code form the keypad selector or press any button on the
transmitter that you want to save.
Once saving is finished the PROG LED turns on and the buzzer sounds off for one second.
If the transmitter has been previously saved or the maximum number of registered users is
exceeded the LED blinks quickly and the buzzer sounds off 7 times.
SERVICING UP TO 25 USERS
Open only
Select the DIP switches are shown and press the PROG button for 1 second. The PROG blinks.
Within 20 seconds, enter the code on the keypad selector or press a button on the transmitter
you want saved.
Once saving is finished the PROG LED stays lit and the buzzer sounds off for one second.
If the transmitter has been previously saved or the maximum number of registered users exceeded,
the LED blinks quickly and the buzzer sounds off 7 times.
OPEN-CLOSE-INVERT
Select the DIP switches are shown and press the PROG button for 1 second. The PROG blinks.
Within 20 seconds, enter the code on the keypad selector or press a button on the transmitter you
want memorized.
Once saving is finished the PROG LED stays lit and the buzzer sounds off for one second.
If the code has been previously saved or the maximum number of registered users exceeded, the
LED blinks quickly and the buzzer sounds off 7 times.
OPEN-STOP-CLOSE-STOP
Select the DIP switches are shown and press the PROG button for 1 second. The PROG blinks.
Within 20 seconds, enter the code on the keypad selector or press a button on the transmitter
you want memorized.
Once saving is complete, the PRG LED stays on and the buzzer sounds off for 1 second.
If the code has been previously saved or the maximum number of registered users exceeded, the
LED blinks quickly and the buzzer sounds off 7 times.
Deleting all users
Select the DIP switches as shown and press the PROG key on the control board, for 5 seconds.
Once deletion is complete, the PRG LED stays lit and the buzzer sounds off for 1 second.
Resetting parameters
Select the DIP-switches as shown and press the PROG button for 5 seconds.
Once deletion is complete, the PRG LED stays lit and the buzzer sounds off for 1 second.
This function does not delete any users.
To Next Page
Loading...
Need help?
General
