To Next PageTo Next PageWhat to do if my CAME Gate Opener will not open or close?
If your CAME Gate Opener isn't opening or closing, first ensure that the power is on. If the power is on, check if the operator is in manual release mode and reconnect it if necessary. Also, check the remote control batteries and replace them if they are run down. For any other issues, it is best to call assistance.
Why does my CAME Frog-A 24U open but not close?
If your CAME Gate Opener opens but won't close, the issue might be with the photoelectric sensors. Ensure they are clean and in good working order. If the edge sensor is triggered, it is best to call assistance.
General| Power Supply | 24 V DC |
|---|---|
| Max Gate Weight | 800 kg |
| Operating Temperature | -20°C to +55°C |
| Max Leaf Weight | 400 kg |
| Protection Rating | IP67 |
Details entrapment protection requirements for UL325 classes, including primary and secondary methods.
Lists key safety features required for gate operator installations, such as gate edges and guards.
Details conditions for installing the operator, gate construction, and necessary clearances.
Outlines general rules for gate design, construction, and installation according to ASTM F2200.
Addresses upgrades for existing automated gates and specific gate types.
Specifies requirements for horizontal slide gates, including guarding and gap limits.
Details requirements for horizontal swing gates and entrapment area prevention.
Describes how contact edge sensors function to stop and reverse the gate upon obstruction.
Explains how photoelectric sensors detect obstacles and cause gate reversal.
Lists key safety measures for installation and operation to prevent accidents.
Safety advice for electrical connections, power handling, and proper grounding.
Warning about digging and contacting underground utility locating companies.
Details the components included in the product packaging.
Provides a chart for wire gauge and length for electrical connections.
Outlines essential site preparation steps before installation.
Warning about digging and contacting underground utility locating companies.
Illustrates the left-hand installation of the operator assembly.
Illustrates the right-hand installation of the operator assembly.
Shows the placement of the close end stop for the gate.
Shows the general mounting of the control panel.
Illustrates the assembly of the control panel hinges.
Shows how to secure the control panel hinges with screws.
Shows how to attach the control panel cover.
Safety warning regarding power disconnection before servicing the operator.
Illustrates limit switch wiring for left/right hand operators.
Wiring diagrams for single gate operators (right and left-hand).
Wiring diagram for dual gate operators.
Details wiring and configuration for photoelectric sensors.
Function description for the C1 contact input for gate reversal.
Function description for the C2 contact input for gate reversal.
Function description for the C3 contact input for partial stop.
Function description for the C4 contact input for standby obstacle.
Function description for the C7 contact input for edge sensors.
Function description for the C8 contact input for edge sensors.
Details on wiring command and control devices like buttons and keys.
Lists the default factory settings for programmed functions.
Instructions for erasing the radio card's memory.
Describes how to set the menu language.
Explains various operational functions that can be configured.
Details configuration options like encoder, slow run, and end stop settings.
Setting for automatic closing timer.
Setting for automatic partial closing timer for the second gate leaf.
Setting for the duration of gate opening/closing phases.
Provides information on software version and gate run counts.
Motor test to check gearmotor rotation direction.
Guide for adjusting the brake microswitches for precise limits.
How to perform a safety test on photoelectric sensors.
Important notes regarding maintenance and voltage checks.
Guidance on disposing of packing materials responsibly.
Instructions for the proper disposal of the gate operator product.
