25
ADJUSTMENTS
MANUAL RELEASE + TEST PHOTOELECTRIC SENSORS
MANUAL RELEASE
The manual release allows you to manually open or close the gate. The manual
release allows the gate to hook back up when closing. Manual release operations
need to be carried out during emergency procedures and with the power
disconnected.
Refer to the individual manual release instruction for more information.
Manual Release
TEST PHOTOELECTRIC SENSORS
Each open/close command, the electronic card verifies the photoelectric
sensors are connected and working. Any problems with the photoelectric
sensors will cause the (PROG) LED to flash on the electronic card, which
cancels any commands from the remote control or push-button.
1
Electrical connection to operate the photoelectric sensors safety test:
• Connect the transmitter and receiver as shown in the diagram.
2
From the functions menu, select “Safety Tests” and select either CX - CY - CZ
inputs to activate the test.
48
48
#
.#
DIR10 Photoelectric Sensors:
After all adjustments have been completed, attach the cover to the
operator with the provided screws.
To Next Page
Loading...
Need help?
General
