To Next PageTo Next PageWhat to do if my CAME FERNI Gate Opener will not open or close?
If your CAME Gate Opener isn't opening or closing, first ensure that the power is on. If the power is on, check if the operator is in manual release mode and reconnect it if necessary. Also, check the remote control batteries and replace them if they are run down. For any other issues, it is best to call assistance.
Why does my CAME FERNI Gate Opener open but not close?
If your CAME Gate Opener opens but won't close, the issue might be with the photoelectric sensors. Ensure they are clean and in good working order. If the edge sensor is triggered, it is best to call assistance.
General| Max Gate Weight | 800 kg |
|---|---|
| Power Supply | 230 V AC |
| Motor Power | 300 W |
| Operating Temperature | -20°C to +55°C |
| Protection Rating | IP54 |
| Duty Cycle | 30% |
| Maximum Leaf Weight | 800 kg |
| Safety Features | Obstacle detection |
Provides guidelines for safe installation of gate operators and systems.
Mandates installation of two independent entrapment protection systems for each zone.
Crucial safety guidelines for installation, operation, and maintenance to prevent injury or death.
Steps for physically mounting the gate operator unit.
Procedure for installing and adjusting limit switches for gate end stops.
Identifies components and terminals on the control panel and electronic card.
Detailed steps for connecting the operator motor to the control panel.
Instructions for wiring photoelectric sensors and other safety devices.
Guide to navigating the programming menu and its buttons.
Step-by-step guide for initial operator configuration and setup.
Instructions for installing and programming the radio card for remote control access.
Identifies common gate operator malfunctions and their solutions.
