CAME FERNI User Manual

30
TROUBLESHOOTING
TROUBLESHOOTING
MALFUNCTION POTENTIAL CAUSE CHECK AND REMEDIES
The gate will not open or close • There is no power
• The operator is in manual release mode.
• The remote control batteries are run down
• The remote control is broken
• The stop button is either stuck or broken
• The opening/closing button or the key selector are stuck
• Photoelectric sensors in partial stop mode
• Check that the power is on
• Reconnect operator
• Replace batteries
• Call assistance
• Call assistance
• Call assistance
• Call assistance
The gate opens but will not close • The photoelectric sensors are engaged
• Edge sensor triggered
• Check that photoelectric sensors are clean and in
good working order
• Call assistance
The gate closes but will not open • Edge sensor triggered • Call assistance
The flasher does not work • The bulb is burnt • Call assistance
DISPOSAL
DISPOSAL
DISPOSAL OF PRODUCT
Our products are made using different types of materials. The majority of them
(aluminium, plastic, iron, electric cables) can be considered to be solid urban waste.
They may be recycled at authorised firms. Other components (electrical circuit board,
remote control batteries etc.) may contain hazardous waste. They must, thus, be
removed and turned in to licensed firms for their disposal.
Before acting always check the local laws on the matter.
DO NOT DISPOSE OF IN NATURE!
DISPOSAL OF PACKING MATERIALS
The packing components (cardboard, plastic, etc.) are solid urban waste and may be
disposed of without any particular difficulty, by simply separating them so that they
can be recycled.
Before actions it is always advisable to check the pertinent legislation where
installation will take place.
DO NOT DISPOSE OF IN NATURE!

CAME FERNI Specifications

General

Max Gate Weight	800 kg
Power Supply	230 V AC
Motor Power	300 W
Operating Temperature	-20°C to +55°C
Protection Rating	IP54
Duty Cycle	30%
Maximum Leaf Weight	800 kg
Safety Features	Obstacle detection