CAME FERNI

22
BASIC SETUP FOR TYPICAL APPLICATIONS
1
Set the LANGUAGE: Press and hold the ENTER button for 1 second to
see the menu on the display. Select LANGUAGE > (Choose the desired
language).
2
Set the basic function for the entrapment protection devices: Select
FUNCTIONS then select the following menus to either determine the
functionality or disable the entrapment protection devices:
• Total Stop > Disabled
• CX Input > (Choose either C1, C2, C3, C4, C7, C8, or
Deactivated)
• CY Input > (Choose either C1, C2, C3, C4, C7, C8, or
Deactivated)
• CZ Input > (Choose either C1, C2, C3, C4, C7, C8, or
Deactivated)
3
Select number of motors: Select IMP. RUN > No. Motors (Choose
either M1 & M2 for dual gates or M2 for a single gate).
4
Select motor type: Select IMP. RUN > Motor type > FERNI.
5
Set the Configuration: Select FUNCTIONS > Config. > Encoder.
6
Set the Encoder: Select ENCODER > Slow run Enc. > OFF.
Basic setup of your operator is now complete. For additional programming and
settings refer to the "Menu Descriptions" pages.
BASIC SETUP FOR TYPICAL APPLICATIONS
PROGRAMMING