19
BASIC SETUP FOR TYPICAL APPLICATIONS
1
Set the LANGUAGE: Press and hold the ENTER button for 1 second to
see the menu on the display. Select LANGUAGE > (Choose the desired
language).
2
Set the basic function for the entrapment protection devices: Select
FUNCTIONS then select the following menus to either determine the
functionality or disable the entrapment protection devices:
• Total Stop > Disabled
• CX Input > (Choose either C1, C2, C3, C4, C7, C8, or
Deactivated)
• CY Input > (Choose either C1, C2, C3, C4, C7, C8, or
Deactivated)
• CZ Input > (Choose either C1, C2, C3, C4, C7, C8, or
Deactivated)
3
Select number of motors: Select IMP. RUN > No. Motors (Choose
either M1 & M2 for dual gates or M2 for a single gate).
4
Select motor type: Select IMP. RUN > Motor type > FROG
5
Set the Configuration: Select FUNCTIONS > Config. > FCAP
RALLCH.
6
Set the End Stop: Select FUNCTIONS > endstop > N.O.
Basic setup of your operator is now complete. For additional programming and
settings refer to the "Menu Descriptions" pages.
BASIC SETUP FOR TYPICAL APPLICATIONS
PROGRAMMING
To Next Page
Loading...
Need help?
General
