+
_
A.C.T. 2M DELAY
SENSAPP./O.T.
SLOW
SPEED
p. 25 - Manual FA00995-EN - 01/2018 - © CAME S.p.A. -
Translation of the original instructions
After adjusting the trimmers, select the DIPs and press the PROG key on the
board as shown in functions programming section.
Trimmer Description of functions
A.C.T.
Automatic Closing Time
It sets the open gate's waiting time. Once this time elapses, the shutter automatically closes.
The wait time can be adjusted to between 1 and 180 seconds.
APP./O.T.
Latching point - with Encoder enabled - or operating time - with Encoder disabled.
It adjusts the motors fi nal resting point before the opening and closing endstops.
The starting fi nal resting point is calculated as a percentage of the gate leave's complete travel, from 1% to
10%.
When the Encoder is disabled, the trimmer is used to set the operating time from 5 to 120 seconds.
2M
DELAY
M2 closing delay time
After a closing command or after an automatic closing, the leaf of gearmotor (M2) starts with a delay
compared to gearmotor (M1) for an adjustable time of between 3 and 25 seconds.
SPEED
Travel speed
It adjusts the speed of the gearmotors during the manuevers.
The speed can be adjusted from 30% (-) to 100% (+).
When the Encoder and the timed slow-downs are disabled, the top speed is 50%.
SLOW
Slow-down speed
It adjusts the gearmotors' speed when slowing down.
The speed may be adjusted from 30% (-) to 60% (+) of the maximum speed.
If the slow down speed is greater than the travel speed, the travel speed is automatically limited.
SENS.
Sensibility
It adjusts the obstruction detection sensitivity during the gate movement.
Minimum sensitivity (-) or maximum sensitivity (+).
Adjusting the trimmers
To Next Page
Loading...
Need help?
General
