s
f1 6 1
1
f1 2 1
1234
1234
1234
[ ] OFF
[
] ON
Page 10 - Manual FA01357-EN - 07/2019 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
F 12 - Setting the Clock
• Enter the programming, select Setting the
Clock [F12] and then [1].
• They will appear sequentially and flashing (
/ to vary, to confirm):
the year (
201 6
), the month (
12
), the day (
31
), the day of the week (
7
);
the time (
23
), the minutes (
59
), the seconds (
59
);
the standard time (
0
winter time/
1
daylight savings time);
the subsequent calibration of the set time (
0
/
1
to activate it).
We suggest that you wait at least one month before checking whether the setting is right.
F 16 - PIN
• Got to Programming, click on PIN [F16] and then
click on [1].
• The default PIN, 1234, will appear. The first number will be flashing. To change the PIN:
[</>] to change the number;
[ESC] to move to the next digit;
[ENTER] to end and confirm the PIN (at any time).
the display will read [Sto] to confirm that the date has been stored.
F 15 - Store in Rolling Code mode
By default [ ], to add Rolling Code transmitters, you
need to access the control board and run the [U1]
procedure.
By selecting [
] you can store the transmitters that you
want to add, and use an already stored transmitter as a
key (please, see the transmitter's packaging).
For protection against tampering and unwanted programming.
Page 10 - Manual FA01357-EN - 07/2019 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructions
To Next Page
Loading...
Need help?
General
