2- 07/2016- © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice.
KEEP ANY REMOTE CONTROL TRANSMITTERS OR ANY
OTHER COMMAND DEVICE AWAY FROM CHILDREN, TO
PREVENT THE OPERATOR FROM BEING ACCIDENTALLY
ACTIVATED. • THIS APPARATUS IS NOT FOR PEOPLE
(
INCLUDING CHILDREN) WITH PHYSICAL, MENTAL
AND SENSORY ISSUES, OR EVEN ONES WITHOUT ANY
EXPERIENCE, PROVIDED THIS HAPPENS UNDER CLOSE
SUPERVISION OR ONCE THEY HAVE BEEN PROPERLY
INSTRUCTED TO USE THE APPARATUS SAFELY AND TO
THE POTENTIAL HAZARDS INVOLVED. • FREQUENTLY
CHECK THE SYSTEM FOR ANY MALFUNCTIONS OR
SIGNS OF WEAR AND TEAR OR DAMAGE TO THE
MOVING STRUCTURES, TO THE COMPONENT PARTS,
ALL ANCHORING POINTS, INCLUDING CABLES AND ANY
ACCESSIBLE CONNECTIONS. KEEP ANY HINGES, MOVING
JOINTS AND SLIDE RAILS PROPERLY LUBRICATED •
P
ERFORM FUNCTIONAL CHECKS ON THE PHOTOCELLS
AND SENSITIVE SAFETY EDGES, EVERY SIX MONTHS.
T
O CHECK WHETHER THE PHOTOCELLS ARE WORKING,
WAVE AN OBJECT IN FRONT OF THEM WHILE THE GATE
IS CLOSING; IF THE OPERATOR INVERTS ITS DIRECTION
OF TRAVEL OR SUDDENLY STOPS, THE PHOTOCELLS ARE
WORKING PROPERLY. THIS IS THE ONLY MAINTENANCE
OPERATION TO DO WITH THE POWER ON. CONSTANTLY
CLEAN THE PHOTOCELLS' GLASS COVERS USING A
SLIGHTLY WATER-MOISTENED CLOTH; DO NOT USE
SOLVENTS OR OTHER CHEMICAL PRODUCTS THAT MAY
RUIN THE DEVICES • IF REPAIRS OR MODIFICATIONS ARE
REQUIRED TO THE SYSTEM, RELEASE THE OPERATOR
AND DO NOT USE IT UNTIL SAFETY CONDITIONS HAVE
BEEN RESTORED • CUT OFF THE POWER-SUPPLY
BEFORE RELEASING THE OPERATOR FOR MANUAL
OPENINGS AND BEFORE ANY OTHER OPERATION, TO
PREVENT ANY RESULTING HAZARDS. SEE INSTRUCTIONS
• I
F THE POWER SUPPLY CABLE IS DAMAGED, IT MUST
BE REPLACED BY THE MANUFACTURER OR AUTHORIZED
TECHNICAL ASSISTANCE SERVICE, OR IN ANY CASE,
BY SIMILARLY QUALIFIED PERSONS, TO PREVENT ANY
RISK • IT IS FORBIDDEN FOR USERS TO PERFORM ANY
OPERATIONS THAT ARE NOT EXPRESSLY REQUIRED OF
THEM AND WHICH ARE NOT LISTED IN THE MANUALS.
F
OR ANY REPAIRS, MODIFICATIONS / ADJUSTMENTS,
AND FOR EXTRA-ORDINARY MAINTENANCE, CALL
TECHNICAL ASSISTANCE • LOG THE JOB AND CHECKS
INTO THE PERIODIC MAINTENANCE LOG.
FURTHER RECOMMENDATIONS FOR ALL
• KEEP CLEAR OF HINGES AND MECHANICAL MOVING
PARTS • DO NOT ENTER THE OPERATOR'S AREA OF
OPERATION WHEN IT IS MOVING • DO NOT COUNTER
THE OPERATOR'S MOVEMENT AS THIS COULD RESULT
IN DANGEROUS SITUATIONS • ALWAYS PAY SPECIAL
ATTENTION TO ANY DANGEROUS POINTS, WHICH HAVE
TO BE LABELED WITH SPECIFIC PICTOGRAMS AND/
OR BLACK AND YELLOW STRIPES • WHILE USING A
SELECTOR SWITCH OR A COMMAND IN MAINTAINED
ACTIONS, KEEP CHECKING THAT THERE ARE NO PERSONS
WITHIN THE OPERATING RANGE OF ANY MOVING PARTS,
UNTIL THE COMMAND IS RELEASED • THE OPERATOR
MAY MOVE THE DOOR AT ANY TIME AND WITHOUT
WARNING • ALWAYS CUT OFF THE MAINS POWER
SUPPLY BEFORE PERFORMING ANY MAINTENANCE OR
CLEANING. • OBSERVE THE MOVING DOORS AND KEEP
PEOPLE AWAY UNTIL THE DOOR IS FULLY OPENED OR
CLOSED.
Danger of hand crushing
Danger! High voltage.
No transiting while the barrier
is moving
Danger of foot crushing
To Next Page
Loading...
Need help?
General
