To Next Page
D
Douglas SantosAug 20, 2025
Why does my CAME Gate Opener open, but not close?
- JJonathan DanielsAug 20, 2025
If your CAME Gate Opener opens but doesn't close, the NO command contact (7-2) might be open.
Why does my CAME Gate Opener open, but not close?
If your CAME Gate Opener opens but doesn't close, the NO command contact (7-2) might be open.
Why does my CAME Gate Opener close, but not open?
If your CAME Gate Opener closes but doesn't open, the NC safety contact (2-C1) might be open.
How to fix a CAME Gate Opener that reverses direction?
If your CAME Gate Opener reverses direction, try adjusting the sensitivity on menu 4.
How to troubleshoot a CAME Gate Opener that won't open or close?
If your CAME Gate Opener isn't opening or closing, begin by checking the power supply and line fuses to ensure they are functioning correctly.
How to fix a CAME Gate Opener that doesn't close automatically?
If your CAME Gate Opener does not close automatically, adjust the sensitivity on menu 4.
Why is my CAME Gate Opener transmitter not working?
If the transmitter for your CAME Gate Opener isn't working, verify that a time is set on menu 7.
What causes a CAME Gate Opener to reverse direction at the end run?
If your CAME Gate Opener reverses direction at the end of its run, check the belt or chain tension.
Why does my CAME Gate Opener start slowly?
If your CAME Gate Opener starts slowly, the encoder might be malfunctioning. Try disconnecting and reconnecting power to the board.
General| Protection Rating | IP40 |
|---|---|
| Power Supply | 230 V AC |
| Motor Type | DC |
| Lifting Capacity | 600 kg |
| Power Consumption | 600 W |
Important safety instructions for people: READ CAREFULLY!
Essential checks before starting installation, including power supply and cable protection.
Lists key operational features managed by the control board.
Explains how the operator reacts to obstacles during movement.
Procedure to define the fully open position for the garage door.
Procedure to define the fully closed position for the garage door.
Process for the operator to learn the door's travel path.
Procedure to add new remote control transmitters to the system.
Process to remove unauthorized or old remote control transmitters.
