Why does my CAME Gate Opener open but not close?
If your CAME Gate Opener opens but doesn't close, it could be due to the following: * The NO command contact (7-2) is open. * The NC safety contact (2-C1) is open. * The NC safety contacts are open.
Why is the voltage LED off on my CAME Gate Opener?
If the voltage present indicator LED is off on your CAME Gate Opener, check the power supply and line fuses.
What to do if CAME Gate Opener closes but doesn't open?
If your CAME Gate Opener closes but does not open, verify that a time is set on menu 7, check the correct direction of travel, and re-memorise the radio code.
Why does my CAME Gate Opener reverse direction?
If your CAME Gate Opener reverses direction, the encoder might be malfunctioning. Disconnect and reconnect power to the board.
Why does my CAME Gate Opener reverse direction at the end run?
If your CAME Gate Opener reverses direction at the end run, the encoder might be malfunctioning. Disconnect and reconnect power to the board.
General| Protection Rating | IP40 |
|---|---|
| Power Supply | 230 V AC |
| Motor Type | DC |
| Lifting Capacity | 600 kg |
| Power Consumption | 600 W |
Important safety instructions for people: READ CAREFULLY!
Essential checks before starting installation, including power supply and cable protection.
Lists key operational features managed by the control board.
Explains how the operator reacts to obstacles during movement.
Procedure to define the fully open position for the garage door.
Procedure to define the fully closed position for the garage door.
Process for the operator to learn the door's travel path.
Procedure to add new remote control transmitters to the system.
Process to remove unauthorized or old remote control transmitters.
To Next Page
