1- 05/2015- © Came S.p.A. - The manual's contents may be edited at any time without notice.
⚠The operator emits a sound signal for 20 seconds before the door starts to automatically close. Simultaneou-
sly, the courtesy light fl ashes. When the door starts closing, the operator emits a sound signal and the courtesy
light comes on. When the door is closed, the operator does not emit any sound signal and the courtesy light
stays on for three minutes.
Activating the radio control
Additional external antenna
Disconnect the internal antenna and connect the external one to the
corresponding terminals on the control board.
Radio frequency card
⚠ For proper functioning, before fitting any AF snap-in card, you MUST
CUT OFF THE MAINS POWER SUPPLY.
Memorizing the transmitters
You can memorize up to 16* di erent codes/users. When the operator is idle:
1 Press and keep pressed S until
2
0 appears on the left side of the display. The segments of the 0 on the left side of
the display rotate clockwise.
3 Press the key that you want to memorize twice consecutively.
⚠* When you try to memorize the 17th code (or transmitter) the courtesy light flashes slowly five times to
signal that the memory is full.
Deleting transmitters
1
Press and keep pressed S until
2
0 appears on the left side of the display. The segments of the 0 on the right side of the display
rotate clockwise.
3
When the 0 on the left disappears, release the S key: the transmitters have been deleted.
To Next Page
Loading...
Need help?
General
