0.1
01
/
2009
© CAME cancelli automatici s.p.a. -
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
- To clean the photocells use a water dampened cloth. Do not use solvents or other chemical products which may ruin the devices.
- In the event of any strange vibrations or squeaking, lubricate the joints with grease, as shown in the diagram.
- Make sure there are no plants within the photocell’s beam, and that the heavy door motion is free of any obstacles.
10.2 Problem solving
MALFUNCTIONS REFERENCES CHECKS
The automation does not open nor close 1-3 1 - Check the power supply and the line fuses
The automation opens but does not close 4-10-23 3 - The N.C. (1-2) safety contact is open
The automation closes but does not open 23 4 - The N.C. (2-C1) safety contact is open
The automation does not automatically close 9-10 5 - The N.C. safety contacts are open
The remote control does not work 12-14 6 - Deactivate the obstruction detection function using the dip-
switches
The automation exerts too much force 16 9 - Check that the A.C.T. trimmer is not set to minimum
The automation exerts too little force 16-17-23-24 10 - Check the proper direction of motion
The automation inverts the direction of movement 16-17-23-24 11 - N.C. command button instead of N.O.
Only one remote control works 18 12 - Check the fuse bridge on AF43S, remove/put power back on
The photocell does not work 4-19 14 - Memorise the radio code again
The led indicator flashes quickly 4-25-26 16 - Ad just the sensitivity using the TRIMMER
The led indicator stays on 11 17 - Eliminating mechanical friction
The led power-on indicator is off 3-1 18 - Insert (or duplicate) the same code in all the remote controls
The automation does not work with the
emergency batteries
6-21-22 19 - Check the proper functioning of the photocell
The automation inverts the direction of movement
at the end of the cycle
10-17-23 21 - Check the batteries
The automation starts slowly 17-23-24 22 - Respect the polarity of the photocells and accessories
23 - Checking the balancing of the overhead door
24 - Checking the tension of the belt/chain
25 - Encoder multifunctioning: cut off and give back power to the card
26 - Erroneous Encoder connection: check the connections
To Next Page
Loading...
