CAME V700E - Remote Control Activation; Antenna and Radio Frequency Setup; Transmitter Identification

CL.SENS.
ZL56A
OP.SENS.
MOTOR FUSE
8A-F
2
1
ON
ACC. FUSE 3,15A-F
LINE FUSE
1,6A-F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS
C.BOARD FUSE 315mA-F
L1T
L
L2T
N
:,
-/4/2&53%
!&
,).%&53%
!&
!&
,4
,
,4
.
ATOMO
AT01 • AT02 • AT04
CAME
CAME
CAME
C
A
M
E
C
A
M
E
C
A
M
E
C
A
M
E
TOP
TOP-432NA • TOP-434NA
TOP-432S
TOP
TOP-302A • TOP-304A
TOP
TOP-432A • TOP-434A
TAM
T432 • T434 • T438
TAM-432SA
CAME
CAME
C
A
M
E
TOUCH
TCH 4024 • TCH 4048
TWIN
TWIN2 • TWIN4
C
A
M
E
CAME
CAME
C
A
M
E
C
A
M
E
C
A
M
E
TFM
T132 • T134 • T138
T152 • T154 • T158
AF43S
AF30
AF40
AF150
AF43TW
TWIN
TWIN2 • TWIN4
Pag.
18
18 - Manual code:
119EU87
119EU87 ver.
0.1
0.1 01/2009 © CAME cancelli automatici s.p.a. - The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
Radiofrequency card
Electrical board
8 Activating the remote control
Connect the radiofrequency card to the electrical board AFTER SHUTTING OFF THE POWER (or disconnecting the batteries).
N.B.: The circuit board recognizes the readiofrequency card only when it is running in electrical power.
Connect the antenna with the RG58 cable to the apposite terminals on the board.
1 - Antenna
2 - Radio frequency
3 - Transmitters
WARNING! Can memorise up to a maximum of 24 transmitters that have different codes.
Note: each transmitter that has a different code, may be duplicated for “n” transmitters (of the same series), except for the ATOMO
transmitter.
See attached
instructions
See attached
instructions
See attached
instructions
See attached
instructions
in Key-Block
Mode
in TOP or
TAM modes
See attached instructions