Page 17 - Manual FA01812-EN - 06/2022 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
LEDs and sensors
LEDS AND SENSORS
PROXIMITY
Screen activation
Sensitivity
LIGHT
Activation
LED brightness
Standby pulsation
PROXIMITY
The [PROXIMITY] function, i.e. the screen turning on when you approach the device, is enabled with [SCREEN ACTIVATION].
The sensitivity of the proximity sensor can be set under [SENSITIVITY] by choosing from:
[MAXIMUM] - detection at maximum possible distance
[AVERAGE]
[MINIMUM] - detection at minimum possible distance
The detection distance partly depends on what is detected and the device’s lighting conditions.
LIGHT
The video camera LEDs can be activated or deactivated using [ACTIVATION].
If the LEDs are activated, you must confi gure the brightness under [LED BRIGHTNESS] or the pulsation e ect under [STANDBY
PULSATION].
To Next Page
Loading...
Need help?
General
