TROUBLESHOOTING
My tool is jammed.
• Ensure that if you compress the Screw Feed Assembly that you drive a screw. Double-pumping
may result in two screws loading simultaneously, which will require removal of the second screw.
• Ensure the screw is centered with the drive line in the Screw Feed Assembly.
The screws don’t advance properly.
• Use only CAMO Collated Hidden Fasteners.
• Ensure the screw strip is inserted properly in the Feed Indexer and Nose Piece.
• Ensure fasteners advance properly by adjusting the Tension Setter on the Feed Rail if necessary.
• Lift the tool completely off the work surface after driving each screw.
The screws aren’t penetrating the board surface or fully seating into the board edge.
• Ensure the Driver Drill is not in reverse.
• Ensure the Depth of Drive is set correctly (see factory setting in the Loading the Tool section).
SERVICE/REPAIR
Should your CAMO Edge Pro require service or repair, contact National Nail Customer Service at
800-968-6245.
Should your Driver Drill require service or repair, contact the manufacturer at the number provided
in their Operator’s Manual.
9
&$02('*(3522:1(5·60$18$/:,7+75$16/$7,216LQGG 30
To Next Page
Loading...
