IMPORTANT INFORMATION
TERMINOLOGY
The following terms will apply interchangeably throughout this Owner’s Manual:
Driver Drill / the Drill
Attachment / CAMO
®
Edge Pro
™
/ Edge Pro
Tool – refers to the CAMO Edge Pro assembled with the Driver Drill
PERSONAL SAFETY ITEMS
• Do not use Tool and/or components prior to reading the CAMO Edge Pro Owner’s
Manual and the Operator’s Manual for the Driver Drill.
• Always wear eye protection that conforms to ANSI requirements (Z87.1) and provides
protection against flying particles both from the front and side. Eye protection should be
worn by the operator and by others in the work area. Eye protection is required to
protect against flying fasteners and debris that could possibly cause severe eye injury.
• The employer is responsible to enforce the use of eye protection equipment by the Tool operator
and all other personnel in the work area.
• To prevent accidental injuries:
- Handle the Tool and components with care
- Always assume that the Tool contains fasteners
- Always disconnect the power from the Driver Drill when:
• loading CAMO Collated Hidden Fasteners
• performing inspection, maintenance or repair
• clearing a screw jam
• the Tool is not in use
• leaving the work area
• moving the Tool to another work location
• handing the Tool to another person
• storing the Tool
- To reduce the risk of electric shock and damage to the Tool, never immerse the Tool in
liquid or allow a liquid to flow inside the Tool
- Never point the Tool toward yourself or anyone else
- Never engage in horseplay
- Never hold or carry the Tool with a finger on the trigger.
- Never place a hand or any other part of the body in the fastener discharge area of the
Attachment while the power is connected
OPERATION OF THE TOOL
• Never inspect, maintain, repair, adjust, clear a jam or store the Tool with the power connected.
• Never use the Tool in proximity of flammable gases or liquids, as some tools will create sparks
that can be an ignition source for a fire or explosion.
• Never assume the Tool is empty of fasteners.
• Never point the Tool toward yourself or any other persons.
• Never drive the Tool unless it is in contact with the work-piece.
• Never use the Tool as a hammer or wedging device or drop to the floor from any height.
• Use only CAMO Collated Hidden Fasteners with the CAMO Edge Pro. Never use any fasteners
that are not specified for use with this Attachment. The Edge Pro holds one (1) strip of 50
CAMO Collated Hidden Fasteners.
1
&$02('*(3522:1(5·60$18$/:,7+75$16/$7,216LQGG 30
To Next Page
Loading...
