Camozzi D Series - End Manual Mode; Reset Slave Info: Resets the State of Health and the Number of Cycles Performed by the Valve Which Is Mounted on a Sub-Base (See Paragraph 7.5)

Instruction manual
Series D multipole size 1
5000026173
Version 00
20
The valve island switches to manual mode (11) and the controls (12) appear on the screen
7.4.1 End manual mode: returns the valve island to the "automatic" state
7.4.2 Reset slave info: resets the state of health and the number of cycles performed by the valve which is
mounted on a sub-base (see paragraph 7.5)
Click on the "Send" button (12) to reset the information saved in the sub-base
The information relating to the state of health of the valve and the number of operations performed by the
single solenoid pilot is recorded by the sub-base on which the valve is mounted, should the replacement of a
solenoid valve become malfunctioning or for which the system has highlighted a low state of health (preventive
maintenance) it is necessary to reset this information.
In this way the system will resume recording only the information relating to the new valve fitted.
11
12