Instruction manual
Series D multipole size 1
5000026173
Version 00
7
3. General characteristics and conditions of use
PNEUMATIC
Valve type Spool with seals
Valve functions
5/2 monostable e bistable
2x3/2 NC 2x3/2 NO 1x3/2 NC+1x3/2 NO
5/3 CC – CP – CO
Material
spool: AL - spool seals: HNBR - other seals: NBR - metal body -
technopolymer bottoms and sub-base
Connection
outlet 2 e 4
thread or bushings, tube size variable according to pitch
Temperature 0 ÷ 50 °C
Air Characteristics
filtered and non-lubricated compressed air in class 6.4.4
according to ISO 8573-1: 2010. If lubrication is required, use
only oils with max. Viscosity. 32 Cst and the version with
external servo pilot. The air quality to the servo pilot must be in
class 7.4.4 according to ISO 8573-1: 2010 (do not lubricate).
Valve Size 10 mm
Working pressure -0.9 ÷ 10 bar
Pilot pressure
2 ÷ 7 bar
3.5 ÷ 7 bar (con pressione di lavoro superiore ai 6 bar per la
versione 2x3/2)
Valve flow 250 Nl/min (10.5 mm)
Mounting position everyone
IP protection IP65
ELETTRIC
D-Sub Connector 25 o 44 poles
Max Power consumption 1,5 A
Supply voltage 24 V DC +/-10%
Max coils
22 coils on 11 valve positions (with 25-pin Sub-D connector)
38 coils on 19 valve positions (with 44-pin Sub-D connector)
Switching valve Yellow led
Fault detection led Red led
Operation status LED Green led - WLAN operation, power supply present
Electropilot power 1W (Power reduction to 0,3W after 100 ms)
To Next Page
Loading...