11. To change the SDI-12 address, type aAb!, where a is the current address from the previous
step and b is the new address. Press Enter. The sensor changes its address and responds
with the new address. In the following example, the sensor address is changed from 0 to B.
12. To exit SDI-12 transparent mode, click Close Terminal.
NOTE:
The transparent mode for the Granite-series, CR6, CR3000, CR800-series, CR300-series data
loggers is similar to that shown for the CR1000X.
MetSENS-Series Compact Weather Sensors 32
To Next Page
Loading...