14
Operation
Bluetooth Operation
You can listen to tracks from a media device if it is connected to the unit via BT .
Pair Bluetooth -enabled Devices
You need to pair your BT device with this unit before you connect them for the first time.
Note:
- The operational range between this unit and a Bluetooth device is approximately 10 meters
( without any object between the Bluetooth device and the unit).
- Before you connect a Bluetooth device to this unit, ensure that you know the device’s capabilities.
- Any obstacle between this unit and the device can reduce the operational range. Bluetooth
- If the signal strength is weak, your device may disconnect, but it will re-enter Bluetooth
automatically into pairing mode.
1. During ON mode, press the
If the unit is not paired to any Bluetooth device, the system enters automatically into pairing mode;
or you need to press and hold the PAIR button to start pairing.
2. Activate the Bluetooth function on your device and select the search mode.
” will appear on your BT device.“ Campomatic SB606
Tips:
• If there is already an existing connection, press the PAIR button on the remote control
to re-activate the pairing mode. The existing connection will be interrupted.
• The unit will also be disconnected when your device is moved beyond the operational range.
• If you want to reconnect your device to this unit, place it within the operational range.
• If the device is moved beyond the operational range, when it is brought back, please
check if the device is still connected to the unit.
• If the connection is lost, follow the above instructions to pair your device again to this unit.
button on the remote control to select the Bluetooth mode.
3. Select “Campomatic SB606” in the pairing list.
USB Charging
Important note:
This device is equipped with an energy saving mode: if no signal is given during 19
minutes the device will switch automatically into standby mode in order to save energy
(ERP 2 standard). Please note that low volume setting in the audio source may be
recognized as “no audio signal”: this will affect the capability of signal detection from the
device and can also originate an automatic switch into standby mode. If this happens
please reactivate the audio signal transmission or increase the volume setting on the
audio source player (MP3 player, etc.), in order to resume playback. Please contact the
local service center if the problem remains.
current is 5V/500mA.
You can plug an USB cable in USB socket to charge the mobile device. Output voltage and
To Next Page
Loading...