EasyManua.ls Logo

Campomatic SB606 - Page 7

Campomatic SB606
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
Important safety instructions
- The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids,
as vases shall be placed on apparatus.
- Main plug is used as the disconnect device and it shall remain readily operable. To be completely
disconnected the power input, the mains plug of the apparatus shall be disconnected from the mains
completely.
- The mains plug of apparatus should not be obstructed or should be easily accessed during intended use.
- No naked flame sources such as lighted candles should be placed on the apparatus;
- Minimum distances 2cm around the apparatus for sufficient ventilations;
- The ventilation should not be impeded by covering the ventilation openings with items, such as
newspaper, table-cloths, curtains, etc;
- The use of apparatus in moderate climates;
- The marking plate is located at the back (or bottom) of the apparatus;
- CAUTION: Danger or explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
- Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
- Attention should be drawn to the environmental aspects of battery disposal;
- Excessive sound pressure from earphones and headphones can cause hearing loss.
- ESD remark: In case of malfunction due to electrostatic discharge, just reset the product to resume
normal operation by user.
Service
To reduce the risk of electric shock, do not remove screws. The unit does not contain any
user-serviceable parts. Please leave all maintenance work to qualified personnel.
Do not open any fixed covers as this may expose dangerous voltages.
Maintenance
Ensure the unit is fully unplugged from the power supply before cleaning.
Do not use any type of abrasive pad or abrasive cleaning solutions as these may damage the units
surface.
Do not use liquids to clean the unit.