CONTROLS/INSTRUMENTS
rmo2008-001-061_a
1. High beams
2. Low beams
3. Flash high beams
6) Turn Signal Button
The turn signal button is located near
the left handgrip. It turns off automat-
ically after a normal turn, but you may
have to turn it off manually after a shal-
low turn or lane change.
To turn the signal off, press the button
in.
Turn signals will automatically turn off
after 30 seconds while the vehicle is
moving.
7) Horn Button
The horn button is located near the left
handgrip.
8) Reverse Interlock Lever
(SM5 Model)
The reverse interlock lever is located in
front of the left handgrip. Pull it toward
you with your right hand to allow shift-
ing into reverse. Refer to
SHIFTING
INTO REVERSE (SM5 MODEL)
for de-
tailed instructions.
WARNING
Do not use the reverse interlock
lever while riding forward. You
could lose control.
The hazard warning lights flash when
the vehicle is in reverse.
9) Reverse Button (SE5 Model)
The reverse button is located near the
left handgrip.
rmo2008-004-401_b
1. Reverse button
Push and hold the reverse button
to allow shifting into reverse. Refer
to
SHIFTING INTO REVERSE (SE5
MODEL)
for detailed instructions.
The hazard warning lights flash when
the vehicle is in reverse.
10) Headlight Override
There is a headlight override button on
the front of the right handgrip. Push
and hold the headlight override but-
ton to operate the selected headlights
(low or high beams). This button will
light the high beams even if the ignition
switch is in the OFF position.
The button can be used to illuminate
the inside the front storage compart-
ment. The high beams will reflect on
the inside of compartment lid when it
is opened.
11) Mode (M) Button
A MODE (M) button is located on the
frontof left multifunction switch. Ithas
the same functions as the Mode but-
ton on the multifunction gauge, and is
activated using the finger with the left
hand on the handgrip. Refer to
MUL-
TIFUNCTION GAUGE CLUSTER
for a
detailed explanation.
16
______________
To Next Page
Loading...
Need help?
General
