PROBLEMS
Light Failure
If any light stop working on the vehicle,
replace bulb of defective light.
If the light failure still occurs, have
the vehicle serviced by an authorized
Can-Am roadster dealer.
CAUTION Always turn the ig-
nition switch to the OFF position be-
forereplacingabulbtoavoidelectric
shock.
Always check light operation after re-
placement.
rmo2008-001-084_a
LIGHTS LOCATION — FRONT OF VEHICLE
1. Turn signal light
2. Headlight
3. Position light
rmo2008-001-088_a
LIGHTS LOCATION — REAR OF VEHICLE
1. Tail light/brake light
2. Turn signal light
3. License plate light
Headlight
1. Insert a small flat head screwdriver
in one of the two holes on the upper
console.
2. Press on the screwdriver and gently
pry out the upper corner of the clus-
ter.
3. Insert a finger to maintain the open-
ing of the upper corner.
rmo2008-001-121_a
1. Upper console
2. Press on the screwdriver inside hole
3. Insert finger in opening
4. With the other hand, inser
tthe
screwdriverintheotherholeonthe
upper console.
110
______________