3
CAN Srl – CU 7000 – ENGLISH – Rev 1/2018
Thank you for purchasing a cooking appliance by CAN s.r.l.
It is a quality appliance, made in Italy, capable of accompanying your pleasure
and free-time in a reliable and safe manner, always guaranteeing the highest level
performance.
Installation and use of the appliance is simple and immediate.
We invite you to read this manual carefully: this will enable correct installation and
use which will ensure your appliance is always perfect and efficient over the years.
The instructions in this booklet are only valid for the country of intended use. Gas
supply systems must comply with national legislation in force.
To facilitate reading of this manual, the following symbols are used:
RESTRICTIONS EXPRESSED
Non-compliance with this restriction exposes people and property to
serious damage.
IMPORTANT PROVISIONS FOR SAFETY OF THE INSTALLATION
TECHNICIANS’ AND END USERS’ OF THE APPLIANCE:
Non-compliance with this note can cause material damage and
compromise product operation.
GENERAL INFORMATION
additional information for installation technicians and users
Fig. X ()
These data refer to an element in a figure
CAN S.r.l., as the manufacturer, reserves the right to make changes to its products
and to this manual which it deems necessary without being obliged to provide
advance notification.
The drawings, installation diagrams and tables contained in this manual are
considered approximate and for the purpose of information only.
This product was designed, manufactured and tested in compliance with the
harmonised standards EN 30-1-1:2008+A3:2013, EN 30-2-1:2015; EN
437:2003+A1:2009, therefore the appliance complies with EEC directives in force for
the sector and in particular the essential requirements contained in regulation UE
2016/426. CAN S.r.l. forbids the copying and partial or total reproduction of the
content of this manual and its distribution to third parties without the
manufacturer’s permission.
To Next Page
Loading...
