35
CAN Srl – CU 7000 – ENGLISH – Rev 1/2018
ROUTINE MAINTENANCE
No routine maintenance is required for the appliance, with the
exception of regular cleaning after each use.
CLEANING
Stainless steel surfaces: use a soft cloth lightly soaked in specific
neutral detergent or vinegar heated (for use methods of the cleaning
products, follow the instructions provided by their manufacturer).
Knobs: the knobs must not be removed from the pin on which they are
mounted. To clean, use a soft cloth barely soaked in specific neutral
detergent (for use methods of the cleaning products, follow the
instructions provided by their manufacturer). Ensure no detergent
infiltrates under the knobs. After cleaning the knobs, ensure you have
not accidentally moved them from their “off” position.
Gas rings, caps, grates: after the components have cooled, remove
them from their compartment and wash them with hot water and
detergent for plates. Stubborn dirt on cast iron components can be
removed using a slightly abrasive sponge and a greaser, taking care
not to damage the enamelled parts. After cleaning, abundantly rinse,
carefully dry and then re-assemble the parts with utmost caution
following the diagram in the figure (Fig. 12)
ATTENTION - During and after cleaning, check no holes in the nozzles
are blocked of impurities or that detergent residue remains on the
bottom of the burner bowls. In this case, remove the impurities or
residue by vacuuming without using liquid detergents or similar.
To Next Page
Loading...
