To Next PageTo Next Page
Need help?Do you have a question about the Canadian Spa YUKON SPA and is the answer not in the manual?
General safety precautions to follow when installing and using electrical equipment.
Specific warnings for audio/video equipment related to electrical shock and servicing.
Warning about keeping electrical appliances away from the spa.
Safety measures to prevent accidental drowning of children.
Precautions regarding spa temperature and its effects on health.
Guidelines for pregnant women regarding water temperature and duration of spa use.
Instructions on how to register your spa warranty online.
Recommendation to hire a licensed electrician for spa electrical work.
Procedure for filling the hot tub with water through the filter housing.
Guidance on installing the Glacier Antimicrobial Filter Set.
Instructions to plug in the GFCI to start the hot tub.
Instruction to follow the Spa Chemical Startup Guide to balance water.
Information on the expected time for the water to reach full temperature.
Encouragement to relax and enjoy the new spa.
Advice against installing in freezing temperatures and using a space heater.
Requirement for a licensed electrician for wiring installation.
Requirements for a flat, reinforced base capable of supporting the spa's weight.
Instructions on securing the spa cover and warning against sitting on it.
Guidance on troubleshooting GFCI tripping issues for 240V systems.
Diagram and voltage table for 240V GFCI electrical installation.
Description of the air control feature for injecting air bubbles.
Indicates the location of the spa's speakers.
Control for adjusting the amount of water flowing through waterfalls.
Feature for adding aromatherapy beads to release scented bubbles.
Intake suction for drawing water from the bottom of the tub.
Overview of the control panel buttons and indicators.
Steps involved in starting up the spa control system.
Instructions on how to adjust and set the spa water temperature.
How to activate and cycle through the spa's LED light settings.
Instructions for activating spa pumps for low and high speeds.
How to switch between Ready and Rest modes for heating.
Procedure to change the orientation of the control panel display.
How to set the duration for filtration cycles.
Chemicals to add while the tub is being filled.
Chemical balancing steps after the tub is filled.
Chemical adjustments for alkalinity and pH as needed.
Steps for sanitizing the spa water with Spa Shock and Chlorine.
Procedure for replenishing sanitizer levels with chlorine.
Balancing water based on test strip readings.
Oxidizing water to optimize sanitizer power.
Protecting against hard water and metal buildup.
Soaking and rinsing filters for cleaning.
Guidance on when to replace the Spa Ball.
Procedure for replacing the spa filter according to schedule.
Flushing pipes before draining water.
Procedure for draining and refilling the spa water.
Ensuring the UV-C bulb LED is on during filter cycle.
Warranty details for structural, surface, and equipment of portable spas.
Warranty for structure, surface, and equipment of non-portable spas.
General terms, conditions, and limitations of the spa warranty.
Procedure for claiming warranty service and technician visits.
Exclusions and limitations of liability for the spa manufacturer.
General| Circulation Pump | Yes |
|---|---|
| Ozone Generator | Yes |
| Voltage | 240V |
| Pump | 2 x 5 HP |
| Lighting | LED |
| Insulation | Full foam |
| Control System | Balboa |
| Shell Material | Acrylic |
| Warranty | 5 years |
