Changing Engine Oil Do not ingest liquids
1. Run the engine for 10 minutes to warm up the oil.
2. Your engine is provided with a sump drain pump. Turn the tap to “on”. Use
the hand pump as shown to pump out the oil into a bucket. Turn the tap to off
position and replace end cap.
3. Unscrew the oil filter and replace with a new one. See diagram below
Note: it is best to wrap a plastic bag around the filter, to catch any oil left in the
system. (Always keep your bilges clean!) Before screwing in the new filter spread a
thin film of oil round the rubber gasket to ensure a good seal and screw in – hand
tight.
4. Fill the engine with new oil, refer to page 13 for specification, as described
above.
Note: once you have re-filled the engine will oil, run the engine for about 5 minutes,
so the oil can be pumped around the engine and into the new filter. Stop the engine,
and let it settle for about 10 minutes, and re-check the oil level, fill if required.
Sump drain
Pump
To Next Page
Loading...
