11
Exit through any TIME DELAY DOOR within seconds.
The exit delay time can be programmed from 10 seconds to 150 seconds.
.
.
Once the exit delay time has expired, the keypad will beep twice to confirm that the
system is armed.
If the EXIT PRE-ALARM option is installed, the keypad will beep slowly until 10 seconds
before the delay time expires, then rapidly for the last 10 seconds.
.
OPTION
INSTALLED
The rest of the ARMING THE SYSTEM section explains how to bypass zones before arming the system, as well as
certain arming options our installer can install. However, it's important for you to remember that no matter how your
system is programmed, you will always disarm it in the same way: enter your PIN, then push the # key.
OPTION
INSTALLED
The AUTO HOME ARMING option enables the system to automatically
bypass interior zones if you arm the system but do not leave the premises.
The perimeter zones will be armed and the entry delay will remain intact.
With this option installed, arm the system (enter your PIN and push the # key).
.
If you do not exit before the exit delay time expires, the system will automatically arm
perimeter zones and bypass interior zones.
.
If you exit through an exit delay door, the system will automatically arm interior and
perimeter zones.
To Next Page
Loading...