Important
You cannot print if the ink tank is installed in the wrong position. Be sure to install the ink tank in
the correct position according to the label on the Print Head Holder.
You cannot print unless all the ink tanks are installed. Be sure to install all the ink tanks.
6.
Close the Top Cover.
If you replaced the ink tank during printing, the printer resumes printing automatically.
Note
If the
Alarm
lamp still flashes orange after the Top Cover is closed, refer to the "Alarm Lamp
Flashes Orange" in the " Troubleshooting
" of the on-screen manual:
dvanced Guide
.
When you start printing after replacing the ink tank, the printer starts cleaning the Print Head
automatically. Do not perform any other operations until the printer completes the cleaning of
the Print Head. The
Power
lamp flashes green during cleaning.
If printed ruled lines are printed or the print head position is misaligned, adjust the print head
position.
See
ligning the Print Head
.
The printer may make operating noise when preparing for printing.
Page top
Стр. 47 из 396 стр.Replacing Procedure
To Next Page
Loading...
