2-14
Document and Paper Handling
When loading envelopes
Close the envelope flap.
3 Specify the loaded paper size and type.
“Setting the Paper Size and Type” (→P.2-18)
Precautions when Loading Paper
IMPORTANT
Be sure to align the paper guides with the width of the
paper.
If the paper guides are too loose or too tight, this may result in
misfeeds or paper jams.
When using paper that has been poorly cut
If you use paper that has been poorly cut, multiple sheets of paper
may be fed at once. In this case, fan the paper thoroughly, and then
align the edges of the stack properly on a hard, flat surface.
Do not exceed the load limit mark when loading paper.
Make sure that the paper stack does not exceed the line of the load
limit mark. If the paper stack exceeds the load limit mark lines, this
may result in misfeeds.
When printing on envelopes
Load envelopes with the front side (non-glued side) facing up. You
cannot print on the reverse side of envelopes.
Also, be sure to close the flap before loading envelopes.
NOTE
For more information on supported paper types
e-Manual → Specifications → Paper → Supported Paper Types
Abbreviations on the paper guides inside the paper
cassette
Paper size Paper guide
Legal LGL
Letter LTR
Executive EXEC
CAUTION
Be careful when handling paper.
Handle paper carefully not to cut your hands with the edges
of the paper.
Precautions when inserting the paper cassette
Be careful not to catch your fingers.
To Next Page
Loading...
Need help?
General
