3.
I
Installation Procedure
3) Mount the fixing plates [I] and [2] that come with
the puncher unit at the front and the rear,
respec-
(When Installing the Fin-
tively, using four screws
[31
(binding; ~4
x
6).
isher and the Puncher Unit
at the Same Time)
3.1
.I
Making Preparing on the Host
Machine
Before connecting the finisherlpuncher unit to its
host machine, mount the fixing plate to the host ma-
chine.
1) Detach the blanking covers
[l] and [2] from the left
cover using a nipper.
2) Detach the blanking cover [3] from the left rear
cover using a nipper.
A
When mounting the puncher unit, mount the fix-
ing plate that comes with the puncher unit and
then make the necessary connection.
If the fixing plate [l] cannot be attached because
the blanking part on the host machine's left cover
is small, remove the following parts:
Host machine's front cover (one blanking rub-
ber and two screws)
Host machine's left cover (four screws)
Next, attach the fixing plate
[I] and then attach
the cover in place.
Use the fixing plates
[l] and
[2]
that come with
puncher unit.
the
To Next Page
Loading...
